Triple T-Slide Card

Here is a fun variation on the T-Slide card.  You can have more than one sliding piece on the inside of the card.

Follow the directions for making the basic T-Slide card.  When you get to step 5, you will score 3 slots.  To do this, place the piece back onto the Fiskars cutter.  Line the left edge of the paper at 3 1/2".  Lift the rail on the cutter and place the blade at 1 1/8".  Push the blade down and slide to the 1 7/8" position.  Lift the blade again and position at 2 1/8", push blade down and slide to 2 7/8".  Lift blade and position at 3 1/8", push blade down and slide to 3 7/8".  Slide the whole piece 1/8" to the left on the cutter.  Repeat these cuts above.  Take a xacto knife to cut away the little slot pieces.  

Cut 3 pieces for the inside of the card 5/8" x 3 1/2.  Score the end of each piece at 1/2".  Continue assembling the card at step 7 of the T-Slide instructions.


For this card, I used papers from Parisian Summer and Pink Pirouette designer prints.  The raccoon is from Stampin' Up! Under the Stars and the greetings are from Stampin' Up! Three Little Words.